|
Post by uuy55f on May 29, 2021 20:44:05 GMT
Hi everyone, I'm now the proud owner of a mk1 mini 850 auto. She's an absolute beauty!
She drives really well, very smooth gear changes etc. The only little thing is that she clunk's when going into drive or 1st gear. Performs perfectly other than that.
Anyone ever experienced this?
Cheers
Alan
|
|
|
Post by notamini on May 29, 2021 21:49:13 GMT
To me it is fairly typical. You may have your idle too high. I set mine to 500rpm.
|
|
|
Post by uuy55f on May 29, 2021 22:22:47 GMT
To me it is fairly typical. You may have your idle too high. I set mine to 500rpm Thanks, I was going to adjust the idle, cheers
|
|
|
Post by mra-minis on Jul 23, 2021 0:37:26 GMT
I can be contacted on martin@kmprecisionengineering.com
Bit of a late response, but as above idle too high, and if that doesn't cure it then your forward clutch pack clearances are too large, the book says up to 0.90mm however 0.45mm maximum is better
|
|
|
Post by notamini on Jul 23, 2021 14:55:41 GMT
Martin. What does the Engagement Control Valve do and can it be fitted to transmissions that do not have it? Also, do you know approximately what years have it installed?
|
|
|
Post by mra-minis on Jul 23, 2021 17:57:48 GMT
Martin. What does the Engagement Control Valve do and can it be fitted to transmissions that do not have it? Also, do you know approximately what years have it installed? I can be contacted on martin@kmprecisionengineering.com Hi Mark, It is supposed to make the upshifting smoother,but in reality can make it harsh due to accelerated wear, It could be retro fitted but in all honesty I normally remove them and just build the transmission with more care and get better results. As for years I am not entirely sure but about 68 to 73 I think, and then only to austin 1300 units.
|
|
|
Post by notamini on Jul 23, 2021 22:12:12 GMT
Oh. Like mine? Haha Maybe if I ever take it out, which I really should, I will also remove that.
|
|
|
Post by uuy55f on Jan 30, 2022 20:41:34 GMT
The issue was indeed the idle speed being too high. Set at about 600 rpm now and is very smooth going into drive now. Thanks all
|
|
|
Post by jockduck on Jan 31, 2022 10:11:57 GMT
You sound like a lucky man, please enjoy the little jewel Jock
|
|